Pickit 3 Programmer Software For Programming For more info., please refer the video shown in the attachments. Note: This product comes with 5 pin cable.
The connector uses two device IO pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming. The MPLAB PICkit 3 is connected to the design engineer’s PC using a full-speed USB interface and can connect to the target via a Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB X Integrated Development Environment (IDE). The PICkit 3 can now also reprogram any PIC microcontroller with a simple push of a button: Find out more about Programmer-To-Go function Please consult the PICkit 3 readme to determine Programmer To Go device support limitations. However, when debugging these devices the header must be used. This special MCU has extra pins for PICkit 3 communication and therefore allows the use of all pins on the part for the application.
Some 8-, 14- and 18-pin devices use small header boards with a special MCU for debugging. We will reply back with quotation as soon as possible If you have any questions in the meantime, feel free to contact us here. However, if you are looking for solutions to technical questions please see our Technical Assistance page. You will be required to have a fundamental knowledge of programming and be required to provide your own code.